Thanks zeeshan dear for honoring me so much, I am greatly indebted to you for this favor. I have been following each and every post of this thread with great excitement, so far you have done a great job, well-done.
As you know I have little knowledge in engines and performance mods, I will be more interested when it comes to body and interior work including wiring and putting any optional oem accessory.
Please share any difficulty you face while sourcing and putting any part back on, like the moldings, trim panels, seals and garnish parts.
Here is one suggestion, make provision for any optional accessory while doing the wiring, so that later on whenever you find the respective optional part you have the liberty to just add the part and wire its connector readily, these may include:
parking pole
Rear power radio antenna
Rear fog light
Reverse cam
A pair of horns with >20amps relay (this may already be done)
Bonnet release trigger switch for the security system alarm
Trunk release actuator for remote release of the trunk lid, a part of the security alarm system, etc.
Find 2/3 pin connector pairs from bilal gunj as you may need them while wiring few of the optional parts similar to the one used in the windshield washer bottle.
I wish you best of luck and hope you complete the remaining work satisfactorily the way you wanted and the result comes out exactly what you have dreamed it about.